Field effect in boron doped diamond
- Author
- Gauthier Chicot
- Year
- 2013
- Thesis name in original language
- Effet de champ dans le diamant dopé au bore
- Abstract & Cover
- University
- Institut Néel (Grenoble, France)
- External Link
- Read Thesis
As the demand in high power and high frequency electronics keeps increasing, standard semiconductors, such as silicon, show their limits. Approaches based either on new architectures or on wide band gap materials should allow to overcome these limitations. Among these, diamond offers superlative properties such as a wide band gap, a high breakdown electric field, an outstanding thermal conductivity and high carriers mobility. Thus, it is foreseen as the ultimate semiconductor that can not be surpassed by others. Besides, recent progresses in substrate and epilayer growth allow to consider seriously devices based on diamond semiconductor. Nevertheless, it also suffers from limitations, especially the difficulty to n-dope and the high ionization energy of the boron p-type dopant that results in a low carrier concentration at room temperature. Innovative solutions relying on 2D gas or/and field effect ionization have been proposed to overcome this problem. This PhD work was focused on two of these solutions, which might address different sectors of power electronics. On one hand, high frequency applications are aimed at using boron doped delta-field effect transistors involving a thin highly doped layer between two intrinsic layers, resulting in a conduction combining a high mobility (due to a confinement-induced delocalisation of carriers away from the ionized impurities) with a large carrier concentration (due to metallic behavior). In this work, the growth of nanometric sized delta-layer using an in-situ etching back technique was demonstrated using SIMS and TEM analysis and confirmed by electrical measurements. Then, the temperature dependence of electrical properties of several nanometric scaled delta boron doped layer were investigated experimentally (by Hall effect and four probe measurements) and theoretically over a large temperature range (6 K < T < 500 K). The samples can be classified in two categories with distinct behaviours: • Two samples showed an insulating non metallic conduction dominated by a hopping mechanism with an anomalous exponent of 0.7 which has already been observed in thin metallic films but is not yet well understood. • A metallic conduction was found in a wide variety of delta-layer thickness ranging from less than 2 nm to 40 nm (with sheet carrier from 1014 cm−2 to 5⇥1015 cm−2). Surprisingly, the same mobility value of 3±1 cm2/Vs was measured independently of the delta-layer thickness. Three dimensional and two dimensional mobility models were considered to explain this phenomenon. Scattering mechanisms by ionized impurity (3D) was found to be the best candidate for such low mobility. The model used in this work gives a relative agreement with this value even if a discrepancy remains. Future works are needed to fully understand this particular value. An exact calculation will certainly need a better knowledge of the valence bands (dispersion and/or boundary with localized states) at energy levels close to the Fermi level of such metallic B-doped diamond. Finally, the thinnest metallic layers (< 2 nm with pS ⇠1014 cm−2) reported in this work did not exhibit the expected improvement of the mobility (μ=3 cm2/V.s). The mobility was too low to consider that high frequency diamond delta field effect transistor are able to compete with existing AlGaN/GaN HEMT showing a mobility of 2200 cm2/V.s. On the other hand, high voltage applications are aimed at with metal oxide semiconductor field effect transistor (MOSFET) where the conducting or insulating behavior of the channel is based on the electrostatic control of the band curvature at the oxide/semiconducting diamond interface. During this PhD project, metaloxide- semiconductor (MOS) structures with aluminium oxide (Al2O3) as insulator and p−type (100) mono-crystalline diamond as semiconductor were fabricated and investigated by capacitance versus voltage C(V ) and current versus voltage I(V ) measurements. The aluminum oxide dielectric was deposited using low temperature atomic layer deposition on an oxygenated diamond surface. The C(V ) measurements demonstrate that accumulation, depletion and deep depletion regimes can be controlled by the bias voltage. In the accumulation regime, a frequency dispersion of capacitance value was noticed and has been attributed to the high series resistance of diamond but also to defects involved in a non ideal MOS structures. A band diagram was proposed to explain the surprisingly high leakage current flowing in accumulation regime: the barrier (at the SC/oxide) for holes seems to be very low (⇠ 0.3 eV). For positive voltage (larger than the threshold voltage) a MOS structure is expected to be in the inversion regime only if minority carriers could be provided to the channel. If not, the depletion of the semiconductor will continue until reaching the deep depletion regime. In the case of diamond which has a very large band gap, minority carriers could be thermally generated only by using very low measurement frequency (f n 1 Hz). Thus, the observation of deep depletion regimes in some samples is in accordance to the measurement frequency used and is indicative of a sufficiently clean oxide/diamond interface. It therefore opens the route for the fabrication of a diamond MOSFET in which the electrons will be provided to the channel by n-type drain and source. Nevertheless, a particular attention has to be paid to the oxide investigation in order to improve its quality (insulating properties, barrier for holes) as it will be a key point for the future diamond MOSFET.
