Vapour phase modification of Kevlar fibres

Author
Itxasne Azpitarte
Year
2018
Abstract & Cover

This thesis presents different approaches for the functionalization of Kevlar fibres, which are based on vapour phase infiltration. The three main parts (chapters 3, 4 and 5) show how the infiltration and hybridization of Kevlar with a metal oxide leads to the introduction of new functionalities and improvement of the stability and mechanical properties of this polymer. In the first part, Kevlar fibres were infiltrated with ZnO through VPI and the structure of the created ZnO-Kevlar material was theoretically and experimentally studied. It was shown that this hybrid material consisted of ZnO clusters grown among covalently cross-linked Kevlar chains. The effect of the hybridization on the thermal and UV stability of the fibres was studied showing an increase of almost 10 ºC in the decomposition temperature and the complete suppression of the UV induced degradation, while maintaining 90% of the modulus of toughness. The results were compared with the ZnO-coated Kevlar fibres´ results, showing that not the ZnO coating (which is present in both the coated and the infiltrated samples), but the infiltration and hybridization of Kevlar with ZnO were responsible for the observed improvement. Besides, the negative impact of the ZnO coating on the UV stability of the fibres was also demonstrated. A novel combined ALD/VPI process was presented in the second part. Thanks to this combined process, it is possible to coat a polymeric substrate with a metal oxide, while infiltrating with another metal oxide. Using this ALD/VPI process Al2O3 coated and ZnO infiltrated Kevlar fibres were prepared. Similar to the observations in the previous chapter, these fibres showed improved thermal and UV stability as a consequence of the ZnO-Kevlar hybrid created in the subsurface area. However, contrary to the previous case, the Al2O3 coating increased the modulus of toughness of Kevlar by 10%. Therefore, thanks to unique combination of Al2O3 coating and ZnO infiltration, mechanically improved and UV resistant Kevlar fibres were created. Finally, in the last part the electrical and photocatalytic properties of the ZnO infiltrated Kevlar fibres were analysed. It was theoretically predicted and experimentally proven that due to the interaction between the ZnO and the polymer, the electronic band gap of Kevlar can be reduced. This reduction resulted in increased conductivity and photocurrent generation with visible light illumination. It was confirmed that the conductivity increase arose from the Kevlar-ZnO hybrid as considerable electron flow was maintained after intentional cracking of the exterior ZnO coating. The conductivity was tuned by the number of VPI cycles and by the exposure time. Besides, the shift of the band gap to the visible range was also confirmed by analysing the photocatalytic activity of the hybrid fibres under visible light illumination. In conclusion, the potential of VPI for the functionalization of Kevlar has been proven and a new combined ALD/VPI process has been developed. The already outstanding mechanical properties of Kevlar have been improved and its main weakness, the thermal and UV sensitivity, have been suppressed. Besides, the electronic band gap of the polymer has been reduced, leading to electrical conductivity and photocatalytic activity under visible light. It can be foreseen that the results presented in this work could be improved and applied to other polymer precursor combinations.

Source of Information
https://www.nanogune.eu/es/seminar/phd-defense-vapour-phase-modification-kevlar-fibres
University
University of the Basque Country
(San Sebastian, Spain)
Read Thesis
LinkedIn
linkedin invite