Thin film synthesis of VO2 and VN by gas-solid reactions and atomic layer deposition

Author
Geert Rampelberg
Year
2016
Abstract & Cover

The vanadium-nitrogen system is less complicated compared to the vanadium oxygen system, since only three stable vanadium nitride phases exist. However, apart from reactive sputtering, the synthesis of pure VN thin films with a low re sistivity has proven to be a challenging task due to the ease of oxidation during processing. Nitridation of metallic V has been reported by a few research groups, showing the difficulty of forming nitrides instead of the more favorable vanadium oxides. CVD coatings are often characterized by high impurity levels, leading to high resistivity values, typically one or a few orders of magnitudes higher com pared to films prepared by reactive sputtering. Prior to this work, only one report had been published on ALD of VN from TDEAV precursor and NH3 , however, detailed information on the ALD growth characteristics and properties of the ALD grown films was not published. In this work, the same techniques as those used for the deposition of VO2 thin films (chapter 3) have been applied for the synthesis of low-resistive VN lay ers. The first method was a high-temperature nitridation of PVD grown metallic V films. For this method, it can be concluded that nitridation occurs already at temperatures around 600-700 ◦C, but higher temperatures of at least 900 ◦C, and high heating rates of 5 ◦C/s are required to prevent the formation of vanadium ox ides. These results are in correspondence with available literature. Low resistivity values down to 80 µΩ • cm were obtained, close to the reported bulk value of VN. Concerning the potential use of VN as copper diffusion barrier, it should be stated that the high-temperature nitridation process of V films is not suitable be cause of a few reasons. The most important one is the temperature restriction in BEOL processing, which is limited to approximately 400 to 500 ◦C. In addition, it is believed that for thin films on the order of a few nanometers, oxygen contam ination would be much more severe, leading to an increased resistivity. The second method involved low-temperature ALD from TEMAV and NH3 . The TEMAV precursor is perfectly suited for this purpose, since only V-N bonds are present in the molecule, without any oxygen atoms which might cause oxida tion. Although both thermal and plasma-enhanced ALD processes result in film growth, only films grown from NH3 plasma are characterized by a high purity level and a stoichiometry matching VN. Furthermore, a low resistivity of 200 µΩ • cm was achieved, which was further reduced down to 90 µΩ • cm by post-deposition annealing in a N2 -H2 gas mixture. Apart from silicon wafers, polymer foil was successfully coated as well with low-resistive VN layers at a deposition tempera ture of only 70 ◦C. Ultrathin VN layers, deposited by PE-ALD, show to be effective as copper diffusion barriers. By means of in-situ XRD, the thermal stability of a Cu film on Si was extended from 230 ◦C without barrier to 720 ◦C with barrier. The high oxidation resistance of VN was studied for the ALD films, with the aim of using VN as bottom electrode for switchable VO2 films. However, although the oxidation temperature at low oxygen partial pressures is above the crystalliza tion temperature of ALD VO2 films, a stack of a VN bottom electrode with crys talline VO2 (M1/R) on top was not obtained.

Source of Information
https://biblio.ugent.be/publication/7165247
University
Ghent University, Department of Solid State Sciences, CoCooN research group
(Ghent, Belgium)
Read Thesis
LinkedIn
linkedin invite