Electrical Switching Characteristics of Chalcogenide Thin Films
- Author
- Sijung Yoo
- Year
- 2017
- Abstract & Cover
- Source of Information
- Cheol Seong Hwang
- University
- Seoul National University (Seoul, Korea)
- Read Thesis
Chalcogenide materials have gained tremendous attentions since early report by S. Ovshinksy due to its unique electrical switching characteristics including volatile switching often referred as Ovonic Threshold Switching (OTS), non-volatile switching involving phase change also known as memory switching, and electrochemical metallization (ECM) where chalcogenide is utilized as solid electrolyte based on its high ion conductivity, which establish themselves as key materials for optical storage as well as next-generation non volatile memory application. In this study, detailed studies and application of electrical switching behavior of chalcogenide thin films are presented. First, the mechanism of bipolar resistive switching (BRS) of amorphous Ge2Sb2Te5 (GST) thin film sandwiched between inert electrodes (Ti and Pt) was examined. Typical bipolar resistive switching behavior with a high resistance ratio (~103 ) and reliable switching characteristics was achieved. High-resolution transmission electron microscopy revealed the presence of conductive Te-filament bridging between the top and bottom electrodes through an amorphous GST matrix. The conduction mechanism analysis showed that the low-resistance state was semiconducting and dominated by band transport, whereas Poole-Frenkel conduction governed the carrier transport in the high-resistance state. Thus, the BRS behavior can be attributed to the formation and rupture of the semiconducting Te bridge through the migration of the Te ions in the amorphous GST matrix under a high electric field. The Te ions are provided by the thin (~5nm) Te-rich layer formed at the bottom electrode interface. Second, atomic layer deposition (ALD) of Ge-Sb-Te ternary and Ge-Sb-Se Te quaternary thin films are studied for its possible application to selection device, especially for 3D vertical device utilizing high step coverage capability of ALD. The binary film of Ge-Te, Sb-Te and Sb-Se and its pseudo-binary and pseudo-ternary compounds, namely ternary Ge-Sb Te and quaternary Ge-Sb-Se-Te films were deposited using Ge(OEt)4, Sb(OEt)3, (Me3Si)2Te and (Me3Si)2Se precursors and their self-limited saturation behavior were examined. The composition of pseudo-binary and pseudo-ternary compounds was confirmed to be consist of stoichiometric binary GeTe2, Sb2Te3 and Sb2Se3. The various composition were tested by two-terminal MIM structure device to examine the effect of composition of each elements on switching parameter such as threshold field (Fth) as well as reliability characteristics such as cycling endurance. It was found that variation in Ge : Sb ratio leads to modulation of threshold field while cycling endurance was scarcely improved. On the other hands, increasing Se concentration resulted in great improvement in cycling endurance up to 105 cycle while threshold field was almost unaffected. Third, the phase change behavior in multiple layer of the ultrathin GST film and consequent optical contrast and its application are presented. The multiple color appearance is basically based on large optical shift originated from the phase transition of multiple ultrathin GST films separated by the dielectric oxide barrier layer. The stacking of multiple layer of GST film and selective phase transition of each layer results in the modification of the strong interference effect and concomitant variable color appearance. It is shown that the reflective static color optical coating whose color can be switched is realized by stacking of more than one layer of ultrathin (< 10nm) GST on the colored substrate. The gradual shift in reflectance spectral position is resulted from the selective phase transition of GST layers and confirmed by optical transfer matrix simulation. Also, the feasibility of nanoscale image recording by static color switching is demonstrated by conductive atomic force microscopy.
