Deposition of TiO2-Al2O3 nanolaminates by the atomic layer deposition technique: study of the process and material characteristics

Author
Giorgio Ernesto Testoni
Year
2017
Language of the thesis
Portuguese
Thesis name in original language
DEPOSIÇÃO DE NANOLAMINADOS DE TIO2 - AL2O3 PELA TÉCNICA DE DEPOSIÇÃO POR CAMADA ATÔMICA: ESTUDO DO PROCESSO E DAS CARACTERÍSTICAS DO MATERIAL
Abstract & Cover

In this work Ti02/Al203 nanolaminated are being investigated to obtain unique materials with chemical, physical, optical, electrical and mechanical properties for a broad range of applications that include from the electronic devices and energy storage until the coatings for biomedical applications such as biomaterials. Here, we discuss the properties of Ti02/Al203 nanolaminate structures constructed on silicon (1 0 0) and glass substrates using atomic layer deposition (ALD) by alternatively depositing a TiO 2 sublayer and Al203 partial-monolayer. These depositions were done in two modes, thermal (ALD) and Plasma-Enhanced (PEALD). In the thermal mode TTIP-H20 and TMA-H20 precursors for TiO2 and Al203 formation were used as precursors, respectively. In plasma mode, the oxygen precursor, H2O was replaced by an 02 plasma. The Al203 is formed by a single TMA-H20 or TMA-02 plasma cycle, so it is a partial-monolayer because of steric hindrance of the precursors, while the TiO2 sublayer is formed by several TTIP-H20 or TTIP-02 plasma cycles. Overall, each nanolaminate incorporates a certain number of Al203 partial-monolayers with this number varying from 10-90 in the Ti02/Al203 nanolaminate grown during 2700 total reation cycles of TiO2 at a temperature of 250 A°C. The fundamental properties of the Ti02/Al203 nanolamines, such as film thickness, chemical composition, microstructure and morphology, were examined in order to better understand the influence of the number of Al203 partial-monolayers on the crystallization mechanism of TiO2. In addition, some optical, electrical and mechanical properties were determined and correlated with the fundamental characteristics. The results clearly show the effect of Al203 partial-monolayers as an internal barrier, which promotes structural inhomogeneity in the film and influences the fundamental properties of the nanolaminate. These properties are correlated with the gas phase analysis that evidenced the poisoning effect of trimethylaluminum (TMA) pulse during the TiO2 layer growth perturbing the growth per cycle and consequently the total film thickness. It was shown that the changes in the fundamental properties of Ti02/Al203 nanolaminates had little influence on optical properties such as band gap and transmittance. However, in contrast, electrical properties as resistivity and mechanical properties as hardness and elastic modulus were shown to be very dependent. Comparison between the two modes of operation ALD and PEALD showed that the plasma mode favors the growth of crystalline films, even in conditions where the thermal mode presented amorphous films.

Source of Information
Dr. Giorgio Ernesto Testoni
University
Instituto Tecnológico de Aeronáutica
(São José dos Campos, Brazil)
Other notes
Kindly supplied by Dr. Giorgio Ernesto Testoni
Read Thesis
LinkedIn
linkedin invite